Micromax Mobile Tricks
There are many tricks for this mobile phone, But we are including only some tips which are more special or useful for people, We also test these tips and code which we share with you, Using our code you can change you mobile phone in many modes like as Engineering Mode, factory Mode, Factory Settings,Using below secret codes of Micromax you can check you IMEI number easily and you can reset your password which you are enable to direct or without your passwords than just do it.
Watch your phones IMEI Number easily Just go on your Phon's main screen jsut Dial 1) *#06# and click on dial or green button wait a second than there will appear some codes like 16 digit number its called IME Number
Check IMEI 1) *#06#
Check IMEI 1) *#06#
If unfortunately you will forget your phone password and you wanna enable to reset your phone password, Than you must wanna reset you phone default setting, But without password its not possible, But its oke using this code you can easily hard reset you phone default setting easily.
just on you phones main screen and just type this code*#987*99# and press dial button and done.
just on you phones main screen and just type this code*#987*99# and press dial button and done.
Restore Factory Settings *#987*99# :
show Check Software Version *#900#
Use For Engineering *#110*01#
show Check Software Version *#900#
Use For Engineering *#110*01#
Use For factory Mode *#987#
Use Change LCD Contrast: *#369#
Micromax Mobile Sectret Codes
(1) *#06# this code show Emei Number
(2) *#110*01# this code show Enter into Engineering Mode
(3) *#987# this code show Enter into factory Mode
(4) *#987*99# this code show Restore Factory Settings
(5) *#900# this code show Check Software Version
(6) *#800# this code Check Software Version
(7) *#369# this code Change LCD Contrast
Some Default User Codes here: 1122, 3344, 1234, 5678
To Enable COM Port: *#110*01# -> Device -> Set UART -> PS Config -> UART1/115200
(1) *#06# this code show Emei Number
(2) *#110*01# this code show Enter into Engineering Mode
(3) *#987# this code show Enter into factory Mode
(4) *#987*99# this code show Restore Factory Settings
(5) *#900# this code show Check Software Version
(6) *#800# this code Check Software Version
(7) *#369# this code Change LCD Contrast
Some Default User Codes here: 1122, 3344, 1234, 5678
To Enable COM Port: *#110*01# -> Device -> Set UART -> PS Config -> UART1/115200
No comments:
Post a Comment